OMNIO - Water sensor H20-ECO
      OMNIO - Water sensor H20-ECO

      OMNIO - Water sensor H20-ECO

      Review (0)
      CHF179.00
      Tax included
      Stock status: Out of stock
      Out of stock
      Out-of-Stock

      The water sensor H20-ECO is aThe water sensor H20-ECO is a battery less, maintenance-free and wireless sensor to detect water. The water sensor H20-ECO is a battery less, maintenance-free and wireless sensor to detect water. A swelling device is attached on the lower side of the sensor

      Quantity :
      • Expert adviceExpert advice for over 14 years
      • Ordered before 5:00 p.m.Ordered before 5:00 p.m. = delivered within 24:00 p.m.
      • Official supplier chosen byOfficial supplier chosen byover 60 manufacturers

      Presentation

      The Omnio ceiling mounted occupancy sensor EOSCA-W-DECKE SOLARPIR is a battery-less and maintenance-free PIR motion sensor with 360 degree viewing angle lens for maximum efficiency in different room settings. It communicates wirelessly with other devices using the EnOcean wireless standard (EEP A5-07-01).

      Two integrated solar cells enable indoor light energy harvesting to power the device and eliminate the need for wires or batteries. In low light environments the device can be powered by an optional coin cell battery. Two molded buttons with LED indicator lights can be used to link and configure the device.

       

      Brief instruction

      Set the Omnio receiver in the programming mode according to its instruction manual

      Press LRN button of Omnio occupancy sensor

      Note : The occupancy sensor must not be further than 5 m away from the Omnio receiver

      Set the Omnio receiver in the operating mode

       

      Product Description

      The water sensor H20-ECO is a battery less, maintenance-free and wireless sensor to detect water. A swelling device is attached on the lower side of the sensor. As soon as it comes in contact with water it starts soaking it up and sends a radio signal. One swelling process takes up to six minutes, after the sixth procedure it will take up to an hour. After ten swelling processes the sensor needs to be replaced. EnOcean Equipment Profile (EEP) F6-05-01, IP43.

       

      technical specifications

      • Operating temperature range
      • Ambient: -25/+65 °C
      • Storage: -25/+65 °C
      • Medium: 1/65 °C
      • Response level: 1.5 mm
      • Response delay: < 6 min (first 5 responses) up to 1 hour (6th to 10th response)
      • Supply voltage: Energy harvesting (via fibre disks)
      • Housing: Plastic housing (PC)
      • Colour: White, similar to RAL 9003
      • W x H x D: 80 x 55 x 30 mm
      • Weight: 66 g
      • Degree of protection: IP 43 (EN 60529)
      •  
      • EnOcean® wireless
      • EEP: F6-05-01
      • Frequency: 868.3 MHz
      • Transmission power: Max. 10 mW
      • Range: 10 to 30 m (depending on room arrangement and materials in the building) 
      •  
      • Scope of delivery:
      • WaterSensor eco
      • Adhesive tape  
      •  
      • Necessary additional components:
      • WaterControl 01 and/or
      • AFRISOhome gateway
      •  
      • Scope of delivery:
      • WaterSensor eco
      • Adhesive tape 
      •  
      • Necessary additional components:
      • WaterControl 01 and/or
      • AFRISOhome gateway
      •  
      •  
      Omnio
      2160153

      Data sheet

      Use
      Fixture Control
      Lighting Control
      Type
      Module
      Function
      Actuator
      Protocol
      EnOcean

      Specific References

      No customer reviews for the moment.

      Write your review
      OMNIO - Water sensor H20-ECO