FIBARO - Z-Wave to DALI Converter for Dimming

Z-Wave to DALI Controller

The Z-Wave to DALI controller is a Z-Wave device that is used to switch ON/OFF and adjust light intensity of DALI control gears on a DALI circuit and can be controlled by other Z-Wave devices. It can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.

The device cannot act as Z-Wave network controller (prima- ry or secondary), so a security enabled controller is needed to take full advantage of all functions for the device.

The encryption modes that the Z-Wave to DALI controller supports are S0, S2 Unauthenticated. When the device is being included into a Z-Wave network, you can use your primary controller/gateway to enable encryption mode or disable encryption. (The primary controller/gateway shall support encryption mode configuration).

SPECIFICATION

• Radio frequency 868.42 MHz (EU)
• Output DALI signal (DALI consumption < 2mA)
• Power Supply 12/24VDC
• Current Consumption 10mA
• Operating temperature 0-40°C
• Relative humidity 8% to 80%
• Dimensions (LxWxH) 45.5 x 45 x 20.3mm