Z-Wave+ wireless actuator to commute charges of 3 A / 230 V. It is used to control hot water boilers or magnetic valves.

This unique type of jet type water meter can be used to measure the volume of cold water (30°C max). It is fitted with a reed type bulb (ILST) pulse emitter.

FIBARO Wall Plug is a HomeKit-compatible smart plug that uses a Wi-Fi® connection and wireless Bluetooth® Low Energy technology.  Warning: This plug is not Swiss format.   

Z-Wave+ "Smart Meter" energy meter module in DIN format for monitoring the consumption of a three-phase electrical installation.  

Pack including the FIBARO Radiator Thermostat (Homekit) and the Bluetooth temperature sensor.

MCOHome Fan Coil Thermostat is a Z-Wave enabled device for indoor temperature control.

This switch enables you to switch the two connected loads either manually as a conventional switch or remotely using wireless Z-Wave Protocol. 

The FIBARO Radiator Thermostat is an intelligent thermostatic head that controls the temperature in your room, using a built-in or external sensor and regulating the heat level according to your individual preferences.

The FGDW-002-7  from Fibaro is a Z-wave PLUS window/door opening sensor fitted with a temperator sensor.This new version is more compact than the previous one.

Pack including the FIBARO Radiator Thermostat (Z-wave+) and the Bluetooth temperature sensor.

The FGDW-002-3  from Fibaro is a Z-wave PLUS window/door opening sensor fitted with a temperator sensor.This new version is more compact than the previous one.

Z-Wave Plus carbon monoxide detector with built-in battery and temperature gauge.

This unique type of jet type water meter can be used to measure the volume of hot water (90°C max). It is fitted with a reed type bulb (ILST) pulse emitter.

The Z-Wave Plus motion detector PSP05-B from Philio can be used both indoors and outdoors. It is supplied with a square recessor.

The Z-Wave Plus motion detector PSP05-B from Philio can be used both indoors and outdoors. It is supplied with a square recessor.

The FGDW-002 from Fibaro is a Z-wave PLUS window/door opening sensor fitted with a temperator sensor.This new version is more compact than the previous one.

The Z-Wave Plus motion detector PSP05-D from Philio can be used both indoors and outdoors. It is supplied with a magnetic mount fitting for easy installation and also includes a lens cover to enable you to exclude an area from the motion detector if so wished.

This switch enables you to control 4 connected loads, either manually as a conventional switch or remotely using wireless Z-Wave Protocol. 

Thanks to the Z-Wave, you can be informed when it starts raining and note the rainfall as well. 

The Aeon Labs electricity consumption meter enables you to check the amount of electricity consumed throughout the home, even for a three-phase installation. This device runs on mains electricity.

The FIBARO KeyFob remote control has 6 buttons allowing you to control all your equipments and run scenarios.

The WallMote Quad from Aeotec is a smart, portable, wall-mounted Z-wave controller.

Fibaro - ON/OFF socket with energy consumption monitoring (French format) FGWPE-102 -ZW5 Warning: This plug is not Swiss format. 

Fibaro - ON/OFF socket with energy consumption monitoring (Schuko format) Warning: This plug is not Swiss format. 

The TZ55D-ZW5 switch allows you to dim or brighten any associated lighting, either manually like a conventional switch, or remotely via the Z-Wave+ wireless protocol.  

The Philio PAT02-1B wireless sensor communicates uses Z-Wave technology to transmit temperature and humidity data.   

The RaZberry 2 is an expansion board that connects directly to the GPIO terminal of a Raspberry Pi board and turns it into a Z-Wave controller

The MH10-PM air quality monitor from MCOHome will help you maintain good air quality in your room.

With MH9-CO 2 sensor by MCOHome, you can maintain good air quality in your room. 12VDC powered version.

MCOHome Fan Coil Thermostat is a Z-Wave enabled device for indoor temperature control.